AUTONET TV

Go With the Flow (MAF Sensor Replacement)

This MAF sensor is an important part of your vehicle.  What it does is calculate the amount of air going into your engine.  As you may know, air is taken into your engine where it's mixed with fuel.  Then the spark plugs fire, the explosive fuel/air mixture detonates, and these sequential explosions provide the power to get your vehicle moving down the road. 

It makes sense that if the MAF sensor isn't sending the engine's computers the correct information about the amount of air entering the engine, the fuel/air mixture won't be right. It will be either too rich (too much gasoline relative to the amount of air) or too lean (not enough gasoline relative to the amount of air).

In this driver's case, the MAF sensor was damaged and needed to be replaced.  Another thing that may cause the MAF to give an incorrect reading is if its wires are dirty or faulty.  So, replacing or cleaning the wires important as well.

Other symptoms that your MAF sensor is bad? If your engine hesitates when you step on the gas, stalls, or your vehicle is jerky when you accelerate. 

A malfunctioning MAF sensor is not just bad for performance.  Driving with your vehicle in that condition can cause more damage to your engine.  When you bring your vehicle in for us to check, a technician will thoroughly examine your engine to make sure all issues are taken care of.

Kingwood Service Center
3318 Northpark Dr
Kingwood, TX 77339
(281) 360-7323
www.kingwoodservicecenter.net